For light-duty bearing removal
(hub bearings, etc.).
Not recommended for
supension bearing removal.
Removes cartridge bearings with an inner race ID
of 10-25 millimeters. A large screwdriver can be
used as a punch from the opposite side (blade placed
in the "fold" of the tool).
A screwdriver can also be used to form a "T-Handle"
(Allowing the bearing to be pulled out from the same
side that the puller is installed from).
Please keep in mind that this puller is designed as an
inexpensive method for bearing removal. It is not designed for extended use. If Loctite® or other fixative has been used on the bearings, this puller may not stand up to the force required to break the bearings free.